Installation Guide. –
Skip to content

🚚Free shipping to Ireland | Tyre lifetime guarantee🚗

Get in touch with us!

Installation Guide.

Step 1

Place The Pump into the 20Ltr container and twist the threaded socket clockwise onto the container thread until hand tight The pump is caliibrated to inject 4 units of sealant for each complete downward stroke. There are 34 units in one life

Step 2

Clip the dispensing end of the flexible tube onto the return fitted to the pump body and open the ON/OFF switch

Step 3

Switch Open Switch Closed

Step 4

To prepare a new or clean pump, work the handle up and down several times until the flexible tube fils with sealant. Excess sealant will return to the 20 litre container via the return outlet Close the ON/OFF switch

Step 5

With the dispensing clip ready to fit onto the valve, remove the valve core by turning anti-clockwise using the valve core remover tool supplied with each pump

Step 6

Once the valve core is removed, quickly clip the dispensing end over the valve to stop any further air loss and open the ON/OFF switch. The pump will inject sealant against air pressures up 90 PSI so no need to deflate the Tyre.

Step 7

Depress the pump handle to apply the correct amount of sealant for that particular Tyre, according to the downloadable installation charts located on the technical page of our website The pump is calibrated to inject 4 units of sealant for each downward stroke

Step 8

Once installation is complete. Close the ON/OFF switch and remove the dispensing end. Quickly replace the valve core to stop any further air loss

Contact Us

Tel: ROI 1800-938-775
NI 0800 014 9994

Email: or

Save Money

Free Shipping/Installation To Ireland

Never Get A Puncture Again!